Grand Caravan V6-3.3L VIN R (2005)
8.
Match the new harness connector wires to the existing vehicle airbag sensor harness connector wires as follows:
>
For the right (passenger side) supplemental front airbag sensor, match the new harness connector wire colors to the same color wire on the
existing body wire harness.
>
For the left (driver's side) supplemental front airbag sensor, match the new harness connector wire colors to same tracer (stripe) color wire on
the existing body wire harness.
CAUTION:
Ensure that wire color/polarity is correct. Incorrect wire color/polarity will cause illumination of the airbag warning lamp. warning lamp.
9.
Insert the new and existing wire strands (from opposite sides) into the splice band/crimp tool so that they overlap each other inside of the splice
band (Figure 8).
10.
Crimp the splice band and wires together by squeezing the crimping tool handles. The tool will release once the proper crimping force has been
achieved (Figure 8).
11.
Solder the connection together using only rosin-core type solder (Figure. 9).
CAUTION: DO NOT use acid core solder.