Grand Caravan V6-3.3L VIN R (2005)
g.
Remove the two vertical screws holding the front fascia to the front fender.
h.
Carefully remove the front fascia and set it aside.
CAUTION:
Be careful not to scratch the painted surfaces of the front fascia and the front fenders.
i.
Break the supplemental front airbag sensor apart using a suitable tool. Remove broken airbag sensor pieces from the vehicle and discard.
j.
Using a cut-off wheel, cut off the head of the airbag sensor mounting bolt.
k.
Remove and discard the supplemental front airbag sensor bushing.
l.
Using a hammer, carefully drive the bolt and the riv-nut into the lower radiator crossmember.
CAUTION:
Do not distort the structural sheet metal surface where the riv-nut is attached.
m.
Remove the old riv-nut through the access hole of the lower radiator crossmember using a magnetic tool.
NOTE:
Be sure to completely remove the riv-nut from the lower radiator crossmember.
n.
Pre-assemble the new riv-nut by installing the M6 nut and the riv-nut onto the M6 bolt as shown in Figure 4.
o.
Insert the riv-nut-bolt/nut assembly into the body sheet metal hole.