Grand Caravan V6-3.3L VIN R (2005)
p.
Using a 10 mm crows foot, tighten the installation nut to 80 in. lbs. (9 N.m) while holding the head of the installation bolt stationary (Figure
5).
q.
Loosen the installation nut and remove the installation bolt and nut from the riv-nut.
r.
Repeat Steps 7i through 7q for each airbag sensor mounting riv-nut that has broken loose (spins freely).
s.
Clean the supplemental front airbag sensor mounting surface for both sensors.
t.
Install the new supplemental front airbag sensors using the appropriate fasteners included in the Supplemental Front Airbag Sensor Package
CBX2G091:
>
For sensors fastened with self tapping bolts:
a.
Pre-assemble both supplemental front airbag sensors, bolts, and washers as shown in Figure 6.
b.
Position the right and left supplemental front airbag sensor on the vehicle and tighten each self tapping bolt into the mounting hole
about five turns to cut new threads for the larger M7 self tapping bolts.
c.
Tightening the self tapping bolts to 60 in.lbs. (7 N.m).