Grand Caravan AWD V6-3.8L VIN L (2001)
14.
Cut off and discard the two-way connector at the wiring harness for the seat heater control module (Figure 2).
15.
Unhook the seat cushion front, right, and left J-clip retainers.
16.
Lift the seat cushion assembly from the seat pan.
17.
Remove the seat cushion cover from the seat cushion foam.
CAUTION:
Use extreme care when removing the seat cushion cover from the seat cushion foam. The hook and loop strip that holds the seat cover to the
seat cushion foam trench could rip loose from the foam before the fasteners separate. Wedge a plastic trim stick between the two sides of the
hook and loop strips to disengage the strips. Pulling on one side of the strip without holding the other side will pull the strip off the foam
before the two pieces separate. Should the hook and loop fastener separate from the foam, use P/N 04773774 adhesive or equivalent to bond
the strip onto the seat foam.
18.
Install the new seat cushion heater element using the following procedure: