Intrepid V6-2.7L VIN R (2003)
CAUTION: When setting the front Toe on the vehicle, the maximum dimension of exposed threads allowed on the adjuster and outer tie rod
cannot exceed the distance shown in. If the maximum distance is exceeded, inadequate retention of either the adjuster or the outer tie rod can
result. This condition can cause separation of the outer tie rod end from the inner tie rod. Ensure that adjustment sleeve pinch bolts are torqued to
the required specification when Toe setting procedure is completed.
6. Check the front wheel toe setting on vehicle and make required changes. When making front wheel toe adjustments, be sure the maximum exposed
thread requirements are not exceeded.
CAUTION: When torquing the adjuster pinch bolt, the procedure must be followed to ensure adequate retention of the adjuster is obtained. Not
following this procedure, could result in the Toe Setting Adjustment changing and/or the separation of the outer tie rod from the inner tie rod.
7. After completion of the tie rod end installation and the toe adjustment procedure, tighten adjuster pinch bolt to a torque of 38 Nm (28 ft. lbs.).
Make sure the outer tie rod maintains correct perpendicular orientation while tightening the adjuster pinch bolt.
