Journey AWD V6-3.5L (2009)
Parking Brake Cable: Service and Repair
Installation
Front Cable - With Foot Lever
WITH FOOT LEVER
1. Pass most of the front parking brake cable down through the access hole in the floor pan from inside the vehicle.
2. Insert the lever end of the front parking brake cable through the mounting hole in the parking brake lever (2). Slide it through until the cable
retainer fingers on the end of the housing (1) lock in place. Make sure all fingers are engaged preventing removal of the cable from the bracket.
3. Pull the button on the end of cable strand out of housing and route the strand around the cable guide, then rotate the cable strand up and align the
cable with the slot in lever mechanism (1). Slide the cable button (2) into the slot and rotate the cable down into mounted position with the cable
inserted into the guide on the mechanism.
4. Slide any extra cable back into the cable housing. This can be easily done by pulling on the trailing end of the front cable strand that is now under
the vehicle.
5. Install the front parking brake cable floor pan seal into the access hole in the floor pan.
6. Reposition the carpeting back down on the floor.