Journey AWD V6-3.5L (2009)
Solar Sensor: Service and Repair
Sun Sensor - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow
these instructions may result in accidental airbag deployment and possible serious or fatal injury.
1. Disconnect and isolate the negative battery cable.
2. Remove the defroster grille See: Air Register/Service and Repair/Defroster Grille - Removal.
3. Using Trim Stick C-4755 or equivalent (2), gently pry between both sides of the sun sensor assembly (1) and the instrument panel (3) to release
the snap retainers that secure the sun sensor.
4. Disconnect the wire harness connector (2) from the sun sensor assembly (1) and remove the sensor.
