Journey AWD V6-3.5L (2009)
9. Connect the wire harness connector to the A/C pressure transducer.
10. If equipped with ABS, install the ABS control module and pump assembly See: Brakes and Traction Control/Antilock Brakes / Traction Control
Systems/Hydraulic Control Assembly - Antilock Brakes/Service and Repair/Removal and Replacement/Integrated Control Unit (ICU) -
Installation.
11. Install the power steering fluid reservoir See: Steering and Suspension/Steering/Power Steering/Power Steering Fluid Reservoir/Service and
Repair/Reservoir, Power Steering Pump - Installation.
12. Install the engine coolant reservoir See: Engine, Cooling and Exhaust/Cooling System/Coolant Reservoir/Service and Repair/Coolant Recovery
Bottle - Installation.
13. If equipped, position the heat shield (3) onto the three studs (1) located on the dash panel in the engine compartment and install the three retaining
nuts (2). Tighten the nuts to 1 Nm (10 in. lbs.).
NOTE: Illustration shown with front fascia and headlamp removed for clarity.
14. Raise and support the vehicle.
15. Install the bolt (3) that secures the upper portion of the A/C suction line (2) to the right front frame rail. Tighten the bolt securely
16. Install the lower portion of the A/C suction line to the upper suction line See: A/C Suction Line - Installation.
17. Connect the rear section of the A/C liquid line (1) to the A/C receiver/drier (4).
18. Install the nut (5) that secures the rear section of the A/C liquid line (1) to the A/C receiver/drier (4). Tighten the nut to 20 Nm (15 ft. lbs.).
19. Reposition the right front wheel house splash shield to the body See: Body and Frame/Fender/Front Fender/Front Fender Liner/Service and
Repair/Splash Shield - Installation.
20. Lower the vehicle.
21. Reconnect the negative battery cable.
22. If equipped with ABS, bleed the brake system See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Hydraulic Control
Assembly - Antilock Brakes/Service and Repair/Removal and Replacement/Integrated Control Unit (ICU) - Installation.
CAUTION: Do NOT run the engine with a vacuum pump in operation or with a vacuum present within the A/C system when equipped with
the Denso 6SEU16 variable displacement compressor. Failure to follow this caution will result in serious A/C compressor damage.
