Magnum V6-2.7L VIN T (2007)
1. Lubricate caliper piston, piston seal (1) and piston bore (2) with clean, fresh brake fluid.
2. Install NEW piston seal (1) in groove of caliper bore (2). Seal should be started at one area of groove and gently worked around and into the
groove using only your clean fingers to seat it.
3. Install NEW dust boot (1) on piston (2) and work boot lip into groove at top of piston. Stretch boot downward, straightening boot folds, then move
boot back upward as necessary until folds snap uniformly into place.
4. Install piston (1) into caliper piston (2) bore, pressing piston down to bottom of bore using hand-pressure. Using a piece of wood or wooden
hammer handle may also suffice as long as piston and boot damage can be avoided. The dust boot will not seat at this time. Refer to following
step.