Magnum V6-2.7L VIN T (2007)
5. Seat dust boot (3) in caliper counterbore using Installer (2), Special Tool 9315, with Handle (1), Special Tool C-4171. Install dust boot until it
bottoms. Do not over-seat dust boot or damage will occur.
6. Install bleeder screw in correct threaded hole. Caliper housing is not side-specific, so it is important to install bleeder screw in threaded hole that
will be uppermost once caliper is installed on vehicle. Tighten bleeder screw to 15 Nm (125 in. lbs.) torque.
7. Install caliper on vehicle.
Disassembly
DISASSEMBLY
NOTE: Before disassembling the brake caliper, clean and inspect it.
WARNING: Under no condition should high pressure air ever be used to remove a piston from a caliper bore. Personal injury could result
from such practice.
1. Drain brake fluid from caliper.