Magnum V6-3.5L VIN V (2006)
Valve Cover: Service and Repair
Cover Cylinder Head - Right
COVER CYLINDER HEAD - RIGHT
REMOVAL
WARNING: DO NOT START OR RUN ENGINE WITH CYLINDER HEAD COVER REMOVED FROM THE ENGINE. DAMAGE OR
PERSONAL INJURY MAY OCCUR.
1. Disconnect the negative battery cable.
2. Remove the upper intake manifold.
3. Cover lower intake manifold openings during service.
4. Disconnect and remove the three ignition coils (2).
5. Lift up on the wire harness track retaining tabs (4).
6. Remove the ground strap retaining bolt (3) from the cylinder head cover.
7. Completely loosen the cylinder head cover retaining bolts and remove the cylinder head cover.
INSTALLATION
1. Clean cylinder head and cover mating surfaces. Inspect and replace gasket (1) and seals (2) as necessary.
2. To replace spark plug tube seals (2):
a. Using a suitable pry tool, carefully remove tube seals (2).