Magnum V6-3.5L VIN V (2006)
1. Position the electrohydraulic unit in the transmission housing.
2. Insert selector valve (1) in driver of detent plate (2). When installing the electrohydraulic control module in the transmission housing, the plastic
part of the selector valve (1) must engage in the driver of the detent plate (2).
3. Install the Torx socket bolts (3) and torque to 8 Nm (71 inch lbs.).
4. Install a new oil filter (4).
5. Install oil pan (5) and torque the oil pan bolts to 8 Nm (71 inch lbs.).
6. Install the adapter plug (10) into the transmission housing and tighten the bolt (9) to 2.5 Nm (22 inch lbs.).
7. Check O-ring on plug connector (1), and replace if necessary.
8. Install the plug connector (1) into the adapter plug (2). Turn bayonet lock of adapter plug (2) clockwise to connect plug connector (1).
9. Fill the transmission with the correct oil.