Magnum V8-5.7L VIN 2 (2007)
Seat Heater Control Module: Service and Repair
Front Seats
Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the right front seat from the vehicle.
3. Reposition the front carpet assembly aside to gain access to the heated seat module (1).
4. Disconnect the wire harness connector (3) from the heated seat module (1).
5. Unsnap the heated seat module retaining clips (2) from the floor crossmember.
6. Remove the heated seat module (1) from the vehicle.
Installation
INSTALLATION
1. Install the heated seat module (3) in the vehicle.
2. Position the retaining clips (2) with the retaining holes (1) in the floor cross member. Firmly apply even pressure to the module (3) until all four
retaining clips (2) snap into place.
