Magnum SRT-8 V8-6.1L VIN 3 (2006)
8. Unclip sensor cable at rear brake rotor shield (1).
9. Remove screw (2) fastening sensor head (3) to rear knuckle.
10. Remove wheel speed sensor.
INSTALLATION
1. Insert wheel speed sensor head (3) into mounting hole in rear of knuckle.
2. Install screw (2) fastening sensor head (3) to rear knuckle. Tighten Screw to 11 Nm (100 inch lbs.) torque.
3. Install sensor cable at rear brake rotor shield (1).
4. Clip sensor cable (2) to routing clips (3) along toe link.
5. If installing left sensor, clip sensor cable (2) to routing clip (1) above toe link mount on rear crossmember.
