Magnum SRT-8 V8-6.1L VIN 3 (2006)
3. Slide booster push rod (5) onto brake pedal pin (4). Install NEW retaining clip (3) securing push rod to brake pedal.
4. Install and adjust NEW brake lamp switch (2).
5. Connect vacuum hose (3) to check valve (2) on face of booster (1). Do not remove check valve from booster.
6. If equipped with Electronic Stability Program (ESP), connect wiring harness (6) connector at pedal travel sensor (7) on power brake booster (3).
7. If equipped with ESP, connect wiring harness (6) connector at active brake booster solenoid (4).
8. Install master cylinder (1).
9. Install windshield wiper module and components removed to access.
10. Connect battery negative cable (2) to battery post. It is important that this is performed properly.