Magnum SRT-8 V8-6.1L VIN 3 (2006)
Wheel Fastener: Service and Repair
Front
NOTE: Before proceeding, Before proceeding, see Service Precautions.
CAUTION: Wheel mounting studs MUST NOT be hammered out of hub flange of hub and bearing assembly. If a stud is removed by hammering it
out, damage to hub and bearing assembly will occur leading to premature bearing failure.
1. Raise and support vehicle.
2. Remove front wheel and tire assembly.
3. Access and remove front brake rotor.
4. On wheel mounting stud to be removed, install a wheel mounting (lug) nut (1) far enough so the threads on the stud are even with end of nut.
Install Remover (3), Special Tool C-4150A, on hub and bearing flange and wheel stud (5).
5. Tighten screw on Remover, pushing wheel stud (5) out of hub flange. Once shoulder of wheel stud is past flange, remove special tool. Remove nut
from stud and remove stud from hub flange.
INSTALLATION
1. Install replacement wheel stud into flange of hub and bearing from rear. Install stack of washers (1) on wheel stud, then install a standard type
wheel mounting (lug) nut (3) on stud with flat side of lug nut against washers.
2. Tighten nut (3), pulling wheel stud into hub flange. Once head of stud is fully seated against rear of hub flange, remove nut and washers from stud.
3. Install brake rotor and caliper.
4. Install wheel and tire assembly. Tighten wheel mounting (lug) nuts in proper sequence to 150 Nm (110 ft. lbs.) (Police - 190 Nm (140 ft. lbs.))
torque.
5. Lower vehicle.
6. Road test vehicle to ensure proper operation of the brakes.
