Neon L4-2.0L SOHC (1995)
5.
Lubricate the areas shown on Figure 3 with Mopar Multi-Purpose Grease, P/N 4318063.
6.
Install new throwout lever. The lever must be assembled onto the throwout bearing first and both the bearing and lever are installed on the
throwout bearing guide tube and the stud simultaneously (Figure 4).
7.
Install transaxle by reversing the removal procedure. Fill transaxle to bottom of fill hole plug with Mopar Manual Transaxle Fluid (MS9417), P/N
4773167. Use of other types of fluids could result in hard shifting or synchronizer failure.
8.
Neon - Perform the Gearshift Cable Crossover Adjustment following the procedures outlined in the Neon Service Manual on Page 21-4.
Talon - Bleed the Clutch Line following the procedure outlined in the Talon Service Manual on Page 6-6.
REPAIR PROCEDURE: (Condition 2 - Neon Only)
This procedure involves replacing the Clutch Release Cable Assembly.
Following the procedure outlined on page 6-2 and 6-3 in the 1995 Neon Service Manual (Publication No. 81-270-5025), remove and replace the clutch
release cable assembly with cable assembly, P/N 4670400.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Condition 1
Labor Operation No:
06-40-10-96
Neon
2.6 Hrs.
Talon
2.8 Hrs.
