Nitro 2WD V6-4.0L (2007)
i.
Highlight the listed calibration.
j.
Select "Update Controller". Follow on screen instructions.
k.
When the update is complete, select "OK".
l.
Verify the part number at the top of the "Flash HVAC" screen has updated to the new part number.
7.
Perform an A/C system recovery and recharge following the procedures outlined in DealerCONNECT >> Heating and Air Conditioning >>
Standard Procedures >> Follow all CAUTIONS and WARNINGS. **A/C systems on these vehicles were originally charged with 20 ounces of
refrigerant. By performing a system recovery and recharge with 18 ounces of refrigerant, improved A/C performance can be achieved.**
NOTE:
Due to the HVAC programming procedure, a DTC may be set in other modules (TCM, BCM, MIC, SKREEM, etc.) within the vehicle, if so
equipped. Some DTC's may cause the MIL to illuminate. From the "Home" screen select "System View". Then select "All DTCs". Press "Clear All
Stored DTCs" if there are any DTCs shown on the list.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.
