RAM 1500 Truck 2WD V6-3.7L VIN K (2003)
NOTE: Extreme pressure lubrication must be used on the threaded portions of the tool. This will increase the longevity of the tool and insure proper
operation during the removal and installation process.
1. Install the new bushing into the crossmember using special tools 8835-2, 8835-4 and 8835-3 with the bearing and the threaded rod 8838 making
sure to properly orient the bushing.
2. Remove the crossmember from the vise.
3. Install the torsion bar crossmember.
4. Reset the vehicle ride height.
5. Perform a wheel alignment.
INSTALLATION - LOWER CONTROL ARM BUSHINGS - 2WD (LD)
NOTE: HD 4X2 bushings are not serviceable.
LARGE BUSHING
NOTE: Extreme pressure lubrication must be used on the threaded portions of the tool. This will increase the longevity of the tool and insure proper
operation during the removal and installation process.
