RAM 1500 Truck 4WD V8-5.7L (2011)
Fuel Filler Neck: All Technical Service Bulletins
Body /Fuel- Fuel Filler Housing Pops Out Of Opening
NUMBER: 14-005-10
GROUP: Fuel System
DATE: September 21, 2010
THIS SERVICE BULLETIN IS ALSO BEING RELEASED AS RAPID RESPONSE TRANSMITTAL 10-061 FOR 2010 DS RAM TRUCK 1500
PICKUP. ALL APPLICABLE SOLD AND UN-SOLD VIN's HAVE BEEN LOADED. TO VERIFY THAT THIS SERVICE ACTION IS
APPLICABLE TO THE 2010 DS RAM TRUCK 1500 PICKUP, USE VIP OR PERFORM A VIN SEARCH IN TECHCONNECT. APPLICATION
OF THIS SERVICE BULLETIN TO ALL OTHER SOLD UNITS IS BASED UPON THE CUSTOMER EXPERIENCING THE
SYMPTOM/CONDITIONS. ALL REPAIRS ARE REIMBURSABLE WITHIN THE PROVISIONS OF WARRANTY.
SUBJECT:
Fuel Filler Close Out Housing Pops Out Of Sheet Metal
OVERVIEW:
This bulletin involves removing the fuel filler close out housing and file some material off of the tabs that will not lock into place. If tab(s) are broken it
will be necessary to replace the fuel filler close out housing and it still may be necessary to filing some material off of the tab(s) that will not lock into
place
NOTE:
Only remove material from tab(s) that will not lock into place.
MODELS:
2009 - 2011
(DS)
RAM Truck 1500 Pickup
2010 - 2011
(DJ)
RAM Truck 2500 Pickup
2010 - 2011
(D2)
RAM Truck 3500 Pickup
NOTE:
This bulletin applies to vehicles equipped with a single wheel rear axle only built before August 9, 2010 (MDH 0809XX).
SYMPTOM/CONDITION:
The customer may notice that the fuel filler close out housing has popped out from the body on one side or the other.
DISCUSSION:
If the Customer experiences the Symptom/Condition perform the repair procedure.
PARTS REQUIRED:
INSPECTION PROCEDURE:
1. Remove the fuel cap.
