RAM 1500 Truck 4WD V8-5.7L VIN D (2005)
8. Install the lip of the pulley and bearing puller (Special Tool C-6141-1 or equivalent) (1) into the snap ring groove of the pulley and bearing
assembly and install the shaft protector (Special Tool C-6141-2 or equivalent) (2).
CAUTION: Do not apply excessive force to the end of the compressor shaft with the puller center bolt or damage to the shaft may occur.
9. Install the puller through-bolts (Special Tool C-6461 or equivalent) through the puller flange (2) and into the puller jaws (1). Turn the puller center
bolt clockwise until the pulley and bearing assembly is free.
10. Remove the screw and retainer (3) from the wire harness lead (2) of the clutch field coil (1).