RAM 1500 Truck 4WD V8-5.7L VIN D (2005)
N.m (20 in.lbs.).
3. Position the pulley and bearing assembly (1) squarely onto the front of the A/C compressor.
NOTE: Thread the installer fully onto the compressor shaft. Turn the installer nut until the pulley and bearing assembly is fully seated.
4. Using installer (Special Tool C-6871 or equivalent) (2), install the pulley and bearing assembly.
CAUTION: The snap ring must be fully and properly seated in the groove or it will vibrate out, resulting in a clutch failure and severe damage to
the A/C compressor.
NOTE: A new snap ring must be used to secure the pulley and bearing assembly to the A/C compressor. The bevel side of the snap ring must face
outward.
5. Using snap ring pliers (Special Tool C-4574 or equivalent) (2), install the snap ring that secures the pulley and bearing assembly (1) onto the front
of the A/C compressor. Be certain that the snap ring is fully and properly seated in the groove.