RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
7. Connect the remote control to the socket.
8. Install the hook (5), the pin (1) and clip (2) to the end of the wire rope (4).
9. Keep the rope under light tension and spool the rope back onto the winch drum in even layers.
10. Stop frequently to tighten and straighten the layers as necessary.
11. Repeat this process until the winch hook (5) is the same distance from the winch as the full length of the remote control.
12. Using the hook strap, walk the wire rope towards the guide rollers, carefully spooling in the remaining wire rope by pulsing the remote control
switch.
NOTE: If you do not have the hook strap, use a length of cord or similar when handling the hook during servicing of the winch.
13. Store the winch hook on the most outboard loop of the tow hook and remove the slack from the wire rope.
