RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
INSTALLATION
1. Position the front of the console up under the instrument panel.
2. Lower the back of the console and install three new screws.
3. Install the inserts.
4. Install the transmission shifter extension.
5. Position the transmission shifter boot in place and seat the attachment clips fully.
6. Install the 4WD shifter boot.
OverHead Console
REMOVAL
1. Disconnect and isolate the remote negative battery cable.
2. Remove the overhead console retaining screws, located in the sunglass storage bin.
3. Using your fingertips, grasp the sides of the overhead console and pull straight down evenly to disengage the two snap clips at the front of the unit.
4. Lower the overhead console far enough to access the wire harness connectors.
5. Disconnect the EVIC, CMTC electronic module and the reading/courtesy lamps electrical connector.
6. Remove the overhead console from the vehicle.
INSTALLATION
1. Position the overhead console in the vehicle.
2. Connect the EVIC, CMTC electronic module and the reading/courtesy lamps electrical connector.
3. Using your fingertips, grasp the sides of the overhead console and push straight up evenly to engage the two snap clips at the rear of the unit.
4. Install the overhead console retaining screw, located in the front of console. Torque the screw to 1.2 Nm (10 in. lbs.).
5. Connect the remote negative battery cable.
