RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
Glove Compartment: Service and Repair
Glove Box
REMOVAL
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY
STEERING WHEEL, STEERING COLUMN, SEAT BELT TENSIONER, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE
AIRBAG SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE
ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN
ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
1. Partially open the glove box.
2. From the inside of the box press down on the rearward edge of the bin and lower the glove box fully past the stops.
3. Lift the box assembly off of the hinges and remove.
INSTALLATION
1. Engage the glove box hinges and partially close.
2. From the inside of the box press down on the rearward edge of the bin and raise the glove box fully past the stops
3. Check for proper glove box operation.
