RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
1. Open the trim plugs and remove the bolts.
2. Remove the a-pillar trim/grab handle from the a-pillar.
INSTALLATION
1. Position the bottom a-pillar locating tabs and install the a-pillar trim.
2. Install the bolts and tighten to 6 N.m (55 in. lbs.).
3. Close the trim plugs.
A-Pillar Trim and Grab Handle
A-PILLAR TRIM/GRAB HANDLE
REMOVAL
1. Using a small flat-bladed tool, carefully open the two fastener covers (3) located in the a-pillar trim panel (2).
2. Remove the two bolts (4) that secure the a-pillar trim panel to the a-pillar (1) and remove the trim panel.
