RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
Keyless Entry Transmitter Battery: Service and Repair
RKE Transmitter Customer Preferences
Automatic (Rolling) Locks
The rolling locks feature can be toggled ON/OFF by using the DRB III only.
Horn Chirp Disabling / Enabling
The horn chirp can be toggled using a DRB III or by using the Remote Keyless Entry (RKE) transmitter.
To DISABLE (cancel) the horn chirp feature:
1. Enter the vehicle and close all doors.
2. Fasten the seat belt (this will cancel the seat belt chime).
3. Turn the ignition to the ON position.
4. Press and hold the LOCK button for 4 seconds. Within 6 seconds with the LOCK button still depressed, press the UNLOCK button. When a
single chime is heard, release both buttons.
5. Turn the ignition OFF.
6. Cycle the ignition or wait 60 seconds.
7. Test the horn chirp feature by pressing the LOCK button.
If a chime is not heard, program mode was canceled before the feature could be disabled. If necessary, repeat the procedure.
To ENABLE the horn chirp feature, repeat the above procedure.
Optical Chirp (Flash) Disabling / Enabling
The optical chirp can be toggled using a DRB III or by using the Remote Keyless Entry (RKE) transmitter.
To DISABLE (cancel) the optical chirp feature:
1. Enter the vehicle and close all doors.
2. Fasten the seat belt (this will cancel the seat belt chime).
3. Turn the ignition to the ON position.
4. Press and hold the LOCK button for 4 seconds. Within 6 seconds with the LOCK button still depressed, press the PANIC button. When a single
chime is heard, release both buttons.
5. Turn the ignition OFF.
6. Cycle the ignition or wait 60 seconds.
7. Test the optical chirp feature by pressing the LOCK button.
If a chime is not heard, program mode was canceled before the feature could be disabled. If necessary, repeat the procedure.
To ENABLE the optical chirp feature, repeat the above procedure.
Unlock Sequence
The unlock sequence can be toggled using a DRB III or by using the Remote Keyless Entry (RKE) transmitter.
To toggle between Driver door first and Unlock all doors function:
1. Enter the vehicle and close all doors.
2. Fasten the seat belt (this will cancel the seat belt chime).
3. Turn the ignition to the ON position.
4. Press and hold the UNLOCK button for 4 seconds. Within 6 seconds with the UNLOCK button still depressed, press the LOCK button. When a
single chime is heard, release both buttons.
5. Turn the ignition OFF.
6. Cycle the ignition or wait 60 seconds.
If a chime is not heard, program mode was canceled before the feature could be disabled. If necessary, repeat the procedure.
To toggle this feature, repeat the above procedure.
