RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
Power Door Lock Switch: Service and Repair
REMOVAL
The power lock switch on the driver side front door trim panel is integral to the driver door module. (Refer to POWER LOCKS/DOOR MODULE -
REMOVAL).
1. Disconnect and isolate the battery negative cable.
2. Using a trim stick, gently pry the switch bezel from the door panel.
3. Disconnect the electrical harness connector from the switch.
4. Remove switch from bezel.
INSTALLATION
1. Insert switch to bezel.
2. Connect electrical harness connector to switch.
3. Press bezel into place on door trim panel.
4. Connect battery negative cable.
