RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
4. Remove the caliper adapter bolts.
5. Remove the retaining clips and rotor assembly.
Front Brake Rotor
INSTALLATION- FRONT
1. On models with All-Wheel Antilock System (ABS), check condition of tone wheel on hub/bearing. If teeth on wheel are damaged, hub/bearing
assembly will have to be replaced (tone wheel is not serviced separately).
2. Install the rotor onto the hub/bearing wheel studs.
3. Install the caliper adapter assembly and tighten adapter bolts to: 130 ft/lbs.
4. Install the wheel and tire assembly and lower the vehicle.
5. Apply the brakes several times to seat brake pads. Be sure to obtain firm pedal before moving vehicle.
Rear Brake Rotor
INSTALLATION- REAR
1. Install the rotor to the axle shaft.
2. Install the caliper adapter.
3. Install the caliper adapter bolts and tighten the mounting bolts to 135 Nm (100 ft. lbs).
4. Install the disc brake caliper.
5. Install the tire and wheel assembly.
6. Lower the vehicle.
