RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
5. Install the dowels in the cylinder block (Fig. 58).
6. Apply small amount of Mopar Silicone Rubber Adhesive Sealant, or equivalent in the corner of the cap and the cylinder block.
7. Slide the one-piece gasket over the dowels and onto the block.
8. Position the oil pan over the dowels and onto the gasket.
9. Install the oil pan bolts. Tighten the bolts to 24 Nm (215 inch lbs.) torque.
10. Remove the dowels. Install the remaining oil pan bolts. Tighten these bolts to 24 Nm (215 inch lbs.) torque.
11. Lower the engine into the support cushion brackets and tighten the thru bolt nut to the proper torque.
12. Install the drain plug. Tighten drain plug to 34 Nm (25 ft. lbs.) torque.
13. Install the engine to transmission strut.
14. Install exhaust pipe.
15. Lower vehicle.
16. Install dipstick.
17. Connect the negative cable to the battery.
18. Fill crankcase with oil to proper level.
