RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
Power Steering Fluid: Testing and Inspection
STANDARD PROCEDURE - POWER STEERING FLUID LEVEL CHECKING
WARNING: FLUID LEVEL SHOULD BE CHECKED WITH THE ENGINE OFF TO PREVENT PERSONAL INJURY FROM MOVING
PARTS.
CAUTION: MOPAR (MS-9602) ATF+4 is to be used in the power steering system. No other power steering or automatic transmission fluid is to be
used in the system. Damage may result to the power steering pump and system if any other fluid is used, and do not overfill.
The power steering fluid level can be viewed on the dipstick attached to the filler cap. There are two ranges listed on the dipstick, COLD and HOT.
Before opening power steering system, wipe the reservoir filler cap free of dirt and debris. Remove the cap and check the fluid level on its dipstick.
When the fluid is at normal ambient temperature, approximately 21°C to 27°C (70°F to 80°F), the fluid level should read between the minimum and
maximum area of the cold range. When the fluid is hot, fluid level is allowed to read up to the highest end of the HOT range.
Use only Mopar ATF+4 Automatic Transmission Fluid (MS-9602). Do not overfill the power steering system.
