RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
ALWAYS REPLACE DAMAGED OR FAULTY SEAT BELT COMPONENTS WITH THE CORRECT, NEW AND UNUSED REPLACEMENT
PARTS LISTED IN THE MOPAR PARTS CATALOG.
1. From the front of the front seat, reach between the center seat cushion and the adjacent right or left front outboard seat cushion to position the front
outboard seat belt buckle to the seat.
2. From behind the front seat, install and tighten the screw that secures the front outboard seat belt buckle lower anchor to the bracket on the inboard
seat track. Tighten the screw to 25 Nm (18 ft. lbs.).
3. From behind the front seat on the driver side only reconnect the seat belt switch pigtail wire connector to the seat wire harness take out and
connector for the switch located below the inboard edge of the driver side inboard seat track just forward of the buckle lower anchor.
4. On standard cab models only, reinstall the stowage tray onto the rear floor panel behind the seat.
5. On standard cab models, move the outboard seat section (40 percent) opposite the side from which the buckle was replaced to its most rearward
position and tilt the seat back to its upright position.