RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
INSPECTION
Inspect condition of each clutch part after cleaning. Replace the overrunning clutch roller and spring assembly if any rollers or springs are worn or
damaged, or if the roller cage is distorted, or damaged. Replace the cam if worn, cracked or damaged.
Replace the low-reverse drum if the clutch race, roller surface or inside diameter is scored, worn or damaged. Do not remove the clutch race from the
low-reverse drum under any circumstances. Replace the drum and race as an assembly if either component is damaged.
Examine the overdrive piston retainer carefully for wear, cracks, scoring or other damage. Be sure the retainer hub is a snug fit in the case and drum.
Replace the retainer if worn or damaged.
Assembly
46RE - Automatic Transmission
ASSEMBLY
1. Temporarily install overdrive piston retainer in case. Use 3-4 bolts to secure retainer.
2. Align and start new clutch cam in the transmission case. Be sure serrations on cam and in case are aligned (Fig. 205). Then tap cam into case just
enough to hold it in place.
3. Verify that cam is correctly positioned before proceeding any further. Narrow ends of cam ramps should be to left when cam is viewed from front
end of case (Fig. 205).
4. Insert Adapter Tool SP-5124 into piston retainer (Fig. 206).