RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
Seals and Gaskets: Service and Repair
46RE (A-518) 4 Speed
46RE - Automatic Transmission
Extension Housing Seal / REMOVAL
1. Raise vehicle.
2. Mark propeller shaft and axle yoke for alignment reference.
3. Disconnect and remove propeller shaft.
4. Remove old seal with Seal Remover C-3985-B (Fig. 96) from overdrive housing.
INSTALLATION
1. Place seal in position on overdrive housing.
2. Drive seal into overdrive housing with Seal Installer C-3995-A (Fig. 97).
3. Carefully guide propeller shaft slip yoke into housing and onto output shaft splines. Align marks made at removal and connect propeller shaft to
rear axle pinion yoke.