RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
Pilot Bearing: Service and Repair
PILOT BEARING / REMOVAL
1. Remove transmission.
2. Remove clutch cover and disc.
3. Using a suitable blind hole puller to remove pilot bearing.
INSTALLATION
1. Clean bearing bore with solvent and wipe dry with shop towel.
2. Install new bearing with clutch alignment tool (Fig. 10). Drive bearing into place until flush with edge of bearing bore.
CAUTION: Do not allow bearing to become cocked and do not recess bearing.
3. Install clutch disc, pressure plate and transmission.