RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
7. Mark alignment marks on the inner race/hub, bearing cage and housing with dabs of paint (Fig. 6).
8. Clamp C/V joint in a vertical position in an in soft jawed vise.
9. Press down one side of the bearing cage to gain access to the ball at the opposite.
NOTE: If joint is tight, use a hammer and brass drift to loosen the bearing hub. Do not contact the bearing cage with the drift.
10. Remove ball from the bearing cage (Fig. 7).
11. Repeat step above until all six balls are removed from the bearing cage.
