RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
11. Install the joint onto the shaft. Push the joint onto the shaft until the snap ring seats in the groove (Fig. 15).
NOTE: Pull on the joint to verify the span ring has engaged.
12. Position, the boot on the joint in it's original position.
NOTE: Verify boot is not twisted and remove any excess air.
13. Secure both boot clamps (Fig. 16) with Clamp Installer C-4975A. Place tool on clamp bridge and tighten tool until jaws of the tool are closed.
