RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
6. Install new bushing (Fig. 21) onto the housing.
7. Insert the tripod and shaft in the housing.
8. Position the boot on the joint and shaft in its original position (Fig. 22).
NOTE: Verify boot is not twisted and remove any excess air.
9. Measure the distance from the housing end to the end of the boot on the shaft. This measurement should be 260 mm (10.25 inch).
NOTE: If measurement is not correct, allow more or less air into the boot.
10. Secure both boot clamps with Clamp Installer C-4975A. Place tool on clamp bridge and tighten tool until the jaws of the tool are closed.