RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
5. Remove tripod snap ring (Fig. 19).
6. Remove tripod and boot from the half shaft.
7. Clean and inspect CV components for excessive wear and damage. Replace the tripod as a unit only if necessary.
INSTALLATION
1. Clean all C/V joint components and shaft.
2. Slide new boot down the half shaft.
3. Install tripod and tripod snap ring on the half shaft (Fig. 20).
4. Pack grease supplied with the joint/boot into the housing and boot.
5. Coat tripod with supplied grease.
