RAM 1500 Van V8-5.2L VIN Y (1999)
Rear Panel Speaker Remove/Install - Without Cargo Compartment Trim
2. Remove the four screws that secure the speaker mounting bracket to the rear panel reinforcements.
3. Pull the speaker mounting bracket away from the rear panel reinforcements far enough to access the body wire harness connector.
4. Disconnect the body wire harness connector from the speaker connector receptacle.
5. Remove the four nuts that secure the grille to the rear of the speaker mounting bracket.
6. Remove the grille from the front of the speaker mounting bracket.
7. Remove the four screws that secure the speaker to the front of the speaker mounting bracket.
8. Remove the speaker from the rear of the speaker mounting bracket.
Rear Panel Speaker - With Cargo Compartment Trim
1. Disconnect and isolate the battery negative cable.
2. Remove the trim panel from the rear panel.
3. Disconnect the body wire harness connector from the speaker connector receptacle.
Rear Panel Speaker Remove/Install - With Cargo Compartment Trim
4. Remove the four nuts that secure the speaker grille to the rear of the trim panel.
5. Remove the speaker grille from the face of the rear panel trim panel.
6. Remove the four screws that secure the speaker to the face of the rear panel trim panel.
7. Remove the speaker from the rear of the rear panel trim panel.
INSTALLATION
Instrument Panel Speaker
1. Position the speaker onto the instrument panel.
2. Reconnect the speaker wire harness connector to the instrument panel wire harness connector.
3. Position the speaker into the mounting hole on the top of the instrument panel.
4. Install and tighten the two screws that secure the speaker to the top of the instrument panel. Tighten the screws to 2 Nm (17 in. lbs.).
5. Install the top cover onto the instrument panel. Refer to Instrument Panel Top Cover in the Replacement for the procedures.
6. Reconnect the battery negative cable.
Front Door Speaker
1. Position the speaker to the front door inner panel.
2. Reconnect the speaker wire harness connector to the front door wire harness connector.
3. Position the speaker in the mounting hole in the front door inner panel.