RAM 1500 Van V8-5.2L VIN Y (1999)
Glove Box Latch And Handle Remove/Install
3. Remove the four screws that secure the handle and latch unit to the glove box inner door.
4. Remove the handle and latch unit from the glove box inner door.
INSTALLATION
1. Position the handle and latch unit onto the glove box inner door.
2. Install and tighten the four screws that secure the handle and latch unit to the glove box inner door. Tighten the screws to 1.9 Nm (17 in. lbs.).
3. Roll up the glove box into the instrument panel. Refer to Glove Box Roll Down.
4. Reconnect the battery negative cable.
Glove Box Inner Door and Bin Removal and Installation
INNER DOOR AND BIN
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the handle and latch from the glove box. Refer to Glove Box Components - Handle and Latch Removal and Installation.
See: Glove Box Handle and Latch Removal and Installation
3. Remove the glove box from the instrument panel. Refer to Glove Box Removal and Installation.
See: Glove Box Replacement
Glove Box Inner Door And Bin Remove/Install
4. Remove the two screws that secure the bottom of the glove box outer door to the bottom of the glove box bin.
5. Remove the eight screws that secure the inner door and bin unit to the glove box outer door.