RAM 2500 Truck 2WD L6-5.9L DSL Turbo (2008)
10. Flow should be less than 40 ml for 10 seconds of cranking
11. If the flow is greater than 40 ml after step 10, remove the #1 fuel injector supply line. Re-torque the high-pressure connector nut. Cap the #1 fuel port
using tool 9011 on the fuel rail.
12. Crank the engine and perform steps 7 through 9.
13. Measure the amount of fuel in the graduated cylinder.
14. If the amount of fuel is less than 40 ml, remove the #1 high pressure connector and the #1 fuel injector. Inspect for damage, repair/replace as
necessary.
15. If the amount of fuel is not less than 40 ml, repeat steps 12-14 for cylinders 2-6.
16. Install all high-pressure connectors, fuel injectors, and fuel injector supply lines. Repeat steps 1-12 to confirm repair.
Repair
-
Note: DTC's will be set by this process. Remember to go in and clear all DTC's from all modules. Test complete.