RAM 2500 Truck 2WD L6-5.9L DSL Turbo (2008)
Fuel Injector: Service and Repair
Fuel Injector - Removal
REMOVAL
CAUTION: Refer to Cleaning Fuel System Parts.
Six individual, solenoid actuated high-pressure fuel injectors (7) are used. The injectors are vertically mounted into a bored hole in the top of the
cylinder head. This bored hole is located between the intake/exhaust valves. High-pressure connectors, mounted into the side of the cylinder head,
connect each fuel injector to each high-pressure fuel line.
1. Disconnect both negative battery cables from both batteries. Cover and isolate ends of cables.
2. Remove vanity cover.
3. Remove breather assembly and tubes.
4. Remove valve cover See: Engine, Cooling and Exhaust/Engine/Cylinder Head Assembly/Valve Cover/Service and Repair/Removal and
Replacement/Cylinder Head Cover - Removal .
5. Remove all 12 fuel injector wire harness nuts (1) securing integrated wiring harness to all 6 fuel injectors.
6. Remove all 12 fuel injector wire harness nuts (1) securing integrated wiring harness to all 6 fuel injectors.