RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN 7 (2001)
Bell Housing: Service and Repair
CLUTCH HOUSING
REMOVAL
1. Raise and support vehicle.
2. Remove transmission and transfer case, if equipped.
3. Remove the starter from the clutch housing.
4. Remove the clutch housing dust shield from the clutch housing.
5. Remove clutch housing bolts and remove housing from engine (Fig. 22) and (Fig. 23).
INSTALLATION
1. Clean housing mounting surface of engine block with wax and grease remover.
2. Verify that clutch housing alignment dowels are in good condition and properly seated.
3. Transfer slave cylinder, release fork and boot, fork pivot stud, and wire/hose brackets to new housing.