RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN 7 (2001)
4. Lubricate release fork and pivot contact surfaces with Mopar High Temperature wheel bearing grease before installation.
5. Align and install clutch housing on transmission (Fig. 23). Tighten housing bolts closest to alignment dowels first and to the following torque
values:
^
1/4in. diameter "A" bolts are torqued to 4.5 Nm (40 inch lbs.).
^
3/8in. diameter "A" bolts are torqued to 47.5 Nm (35 ft. lbs.).
^
7/16in. diameter ""A" bolts are torqued to 68 Nm (50 ft. lbs.).
^
"B" bolts for 5.2L/5.9L applications are torqued to 41 Nm (30 ft. lbs.).
^
"B" bolts for 5.9L TD/8.0L applications are torqued to 47.5 Nm (35 ft. lbs.).
^
"C" bolts for 5.2/5.9L applications are torqued to 68 Nm (50 ft. lbs.).
^
"C" bolts for 5.9L TD applications are torqued to 47.5 Nm (35 ft. lbs.).
^
"C" bolts for 8.0L applications are torqued to 74.5 Nm (55 ft. lbs.).
6. Install transmission-to-engine strut after installing clutch housing. Tighten bolt attaching strut to clutch housing first and engine bolt last.
7. Install the starter to the clutch housing.
8. Install the clutch housing dust shield to the clutch housing. Tighten the bolts.
9. Install transmission and transfer case, if equipped.