RAM 2500 Truck 2WD V8-5.7L (2008)
8. Disconnect the wire harness connector (2) from the Sentry Key REmote Entry Module (SKREEM) (1).
9. Remove the screw (3) that secures the SKREEM (1) to the steering column (2).
10. Disengage the antenna ring from around the ignition lock cylinder housing and remove the SKREEM.
Installation
INSTALLATION
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service.
Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing
further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental
airbag deployment.
