RAM 2500 Truck 2WD V8-5.7L (2008)
1. Position the Sentry Key REmote Entry Module (SKREEM) (1) onto the steering column (2) with the antenna ring oriented around the ignition lock
cylinder housing.
2. Install and tighten the screw (3) that secures the SKREEM to the steering column housing. Tighten the screw to 2 Nm (20 in. lbs.).
3. Reconnect the wire harness connector (2) to the SKREEM (1).
4. Position the lower shroud (3) onto the steering column (4).
5. From below the steering column, install and tighten the one center screw that secures the lower shroud to the steering column. Tighten the screw to
2 Nm (20 in. lbs.).
6. Position the upper shroud (1) onto the steering column over the lower shroud. On vehicles equipped with an automatic transmission, be certain to
engage the gearshift lever gap hider into the opening in the right side of both shroud halves.
