RAM 2500 Truck 4WD L6-5.9L DSL Turbo VIN 7 (2001)
Servo Mounting at Battery Tray
Servo Cable Clip Remove/Install - Typical
12. Position battery tray with attached servo assembly to gain access to 2 servo mounting nuts.
13. Remove 2 mounting nuts holding servo cable sleeve to bracket.
14. Pull speed control cable sleeve and servo away from servo mounting bracket to expose cable retaining clip and remove clip. Note: The servo
mounting bracket displayed is a typical bracket and may/may not be applicable to this model vehicle.
15. Remove servo from mounting bracket. While removing, note orientation of servo to bracket.
INSTALLATION
With Auto. Trans
1. Position servo to mounting bracket.
2. Align hole in cable connector with hole in servo pin. Install cable-to-servo retaining clip.
3. Insert servo studs through holes in servo mounting bracket.
4. Insert servo studs through holes in servo cable sleeve.
5. Install servo mounting nuts and tighten to 8.5 Nm (75 in. lbs.) torque.
6. Connect vacuum line to servo.
7. Connect electrical connector to servo terminals.