RAM 2500 Truck 4WD L6-5.9L DSL Turbo VIN 7 (2001)
8. Connect servo cable to throttle lever by pushing cable connector rearward onto lever pin while holding lever forward.
9. Install battery tray. Tighten all battery tray mounting hardware to 16 Nm (140 in. lbs.) torque.
10. Position battery into battery tray.
11. If equipped, install battery heat shield.
12. Install battery holddown clamp. Tighten bolt to 4 Nm (35 in. lbs.) torque.
13. Connect positive battery cable to battery.
14. Connect negative battery cables to both batteries.
15. Before starting engine, operate accelerator pedal to check for any binding.
16. Install cable/lever cover.