RAM 2500 Truck 4WD L6-5.9L DSL Turbo VIN 7 (2001)
Vacuum Reservoir HVAC: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the wiper arms from the wiper pivots. Refer to Wipers/Washers for the procedures.
Fig.30 Cowl Plenum Cover/Grille Panel Weatherstrip
3. Remove the weatherstrip along the front edge of the cowl plenum cover/grille panel and the cowl plenum panel.
Fig.31 Cowl Plenum Plastic Screws Removal
4. Remove the plastic screws that secure the cowl plenum cover/grille panel to the studs on the cowl top panel near the base of the windshield .
5. Lift the cowl plenum cover/grille panel from the cowl top far enough to access the vacuum reservoir near the right end of the cowl plenum.
